Viewed products

Number Plate LED Light (pair)


New product

Give your number plate a unique look

More details

7 Items

Rs.549 tax incl.

Add to wishlist

Payment Methods
Payment Methods

Data sheet

Quantity provided1 set
Operating Voltage12 volts DC
Stock ReplacementYes
Do It Yourself (DIY)DIY Possible
DIY difficultyEasy
Tools required for installationStandard tool kit required (we recommend the Kingtony set under Garage & Tools category)
Fastening hardware for installationEverything provided
Country of originImported & Sold in India
Weatherproof Waterproof rating (Ingress Protection IP)IP 64, Dust tight, Splashing of water
Warranty for this productNo warranty
Type of packingHard plastic box

More info

Number Plate LED Light (pair)


  • Direct bolt on to the existing number plate holes
  • Wire pass though the number plate holes for a seamless look
  • Head Dimensions: ~ 18mm length x 12mm diameter
  • Cable length: ~ 73cm
  • SMD LED which are bright and emmit white light (6000K)


  • Most stock number plates are installed with a pair of nuts & bolts
  • Remove these two nut & bolts to reveal holes in the number plate and the frame underneath
  • The LED light needs to be inserted in place of the stock nut and bolted underneath the frame
  • This is a straightforward stock replacement step
  • The LED has a wire pair which will be now visible behind the number plate
  • Route this wire to the stock number plate wire


  • Get two small pieces (10 cms) of 0.5sqm wire (1 sqm will also do). These two wires should be of different colors. We will call these as patch wires.
  • Next we will use the provided Quick Splice Wire Connector (2 red connectors) – check the usage video on our website Quick Splice Wire Connector
  • Tap (no cutting needed) into the stock number plate wire using the Quick Splice Wire Connector and the 2 patch wires
  • Lock the Quick Splice Wire Connector as per the video guide
  • Now connect the Patch wires to the two LED wire’s with correct polarity. Note that the red wire is 12v positive and black wire is ground
  • Test by turning on the tail light on
  • If everything works well, use a quality electrical tape to insulate all wires and secure them properly
  • Ensure that there are no loose wires anywhere Use zip tie to secure any loose wires close to the bike frame


  • 2 number plate led lights
  • 2 Quick Splice Wire Connector (red connectors) 

11 other products in the same category:

Customers who bought this product also bought: